Omron Host Link OPC Server Configuration Guide

Channel Configuration

Serial

Serial Link

Master

IOServer will initiate all requests.

Slave

IOServer will wait for and response to requests.

Set PLC to Monitor mode

On Write Error	Set PLC to Monitor mode when a write to the PLC caused an response code of 0x01 (Execution was not possible because the PC is in RUN mode) from the PLC.
At Start Up	Set PLC to Monitor mode at startup
Never	Never set the mode of the PLC

Buffer Size

Maximum total buffer size. Use multi-frames block format if more than 128 bytes is specified.

Device Configuration

Multi Link Station Address	Address of Link Station. If disabled then single link address mode is used.
Station Address	Address of Device
PLC Type	Support All C-Series and CV-Series PLC. Use C-Series commands set.

Variable Types

Notes:
Writing to bits in words is supported by reading the words, modify the bits and writing it back to the PLC. Up to 464 contiguous bits can be written (for a 128 bytes buffer size) at a time.

Last updated: 23 April 2005